Watercel ZF

Watercel ZF is a modified zeolite-based filter media, developed for the removal of iron and manganese in water treatment systems, contributing to higher water quality and operational efficiency.

Watercel ZF assists in the removal of iron and manganese from water, reducing problems such as:

• Yellowish or darkened water;
• Stains on clothes, dishes and equipment;
• Scaling in pipes;
• Equipment corrosion;
• Low efficiency in reverse osmosis systems;
• Non-compliance with water quality standards.

Yes. In many cases, Watercel ZF can replace media used for iron and manganese removal in existing systems, without the need to replace the filter.

Our technical team can evaluate your application and recommend the best configuration for your system.

In addition to high efficiency in iron and manganese removal, Watercel ZF has an apparent density close to 1 kg/L, lower than that of many conventional media.

This allows for a greater filter bed height, longer contact time, lower water consumption during backwashing, and a smaller amount of product needed to fill the same filter.

Not necessarily.

In filtration systems, what is usually sized is the volume of the filter bed and not the weight of the media. Therefore, media with higher density may seem cheaper per kilogram, but require a larger quantity of product to fill the same filter.

The ideal is to compare the cost per installed volume and the operational performance of the solution.

Yes. Depending on the system characteristics and operating conditions, Watercel ZF can provide significant reductions in water consumption during backwashing.

Real application cases have recorded savings of up to 43%.

Yes. Watercel ZF is widely used in well water treatment systems for the removal of iron and manganese, contributing to the improvement of water quality and protection of equipment.

Yes. The efficient removal of iron and manganese helps protect reverse osmosis membranes, contributing to a longer system service life and reduced operating costs.

Each operation has specific characteristics, such as flow rate, iron and manganese concentration, water quality, and treatment objectives.

Therefore, we do not make generic recommendations. Our technical team evaluates your operational reality to indicate the most suitable solution for your challenges.

Talk to our specialists and receive a technical evaluation of your application.

Each operation has specific characteristics that influence the performance of the filtration system.

As a reference, Watercel ZF can be applied in water with concentrations of up to 11,0 mg/L of iron and 6,0 mg/L of manganese, subject to correct sizing and adequate operating conditions.

Talk to our specialists for a technical evaluation of your application.